When newly installed, the door will be smoothly opened and closed. As time goes by, dust and dirt will stick into the hinges. Long time hinges jammed. The lubricant is no longer functioning properly because it is covered with the particles. Or maybe no longer left lubricant on the door hinges.

When two pieces of metal rub against a pin inside the hinge cylinder, and the lubricant has dried, a screeching sound occurs. Similarly, when the chalk bar is rubbed on the surface of the board. Two rough and dry surfaces will produce friction. Then all you need is something that can wet and smoothing the two dry objects in contact.For more information you can visit Garage door installation.

To remove the sound on the door you just need a lubricant. In addition to lubricate, lubricant also Eliminate stains attached so that the door can open and close easily. The correct way of repair and lubrication will give satisfactory results. For those of you who have a problem on the butterfly hinged door, consider the following tips: Garage maintanance and repair

Remove the Pin from the Hinge Hole

Place a flat-edged screwdriver on the gap between the hinge and the screw pin. Hit the base of the screwdriver with a hammer until the screws are pinched out. Do it on the other side until the pin has been removed from the hinge hole.

Lubrication Holes Pin

After the pin is removed, clean the inside of the hole with a cloth and lubricaksi with graphite lubricant or sewing machine oil.

Clean and coat the pin with oil

Wipe the pin with a cloth, then coat it with the oil on top. Replace hinge pins when showing signs of damage such as wear or has been very rusty. But if the rust is not too severe, you can soak it a few minutes in white vinegar. Rust will fall (though may not be entirely). Remove, wipe with a cloth, then coat it with lubricant. If you replace the pin with a new one, do not forget to keep lubricating as well.

Replace the pin to the hinge hole

Re-enter the elements that have been dismantled in the order of the mounting mechanism. Hit the pin and screw the cover with a hammer to fit in and fasten in the hinge hole.

Tighten the Screws on the Hinge Feet

In addition to fix the pin hinges, also fix screws on the foot hinges. Find a minus or flower screwdriver that fits the installed screws and tighten it. If you are unsure, remove the screws and then plug it in and tighten it again.

Set aside Hinges

After all is checked and re-installed, clean your entire hinge, coat it with lubricant. Make sure your hinges are still good, not rusty a lot. Do it all over the Garage door repair hinges. Try again opening -close your door.