1. Clean the material to be welded. Use the hammer to clean the crust on the surface of the area to be welded. Use a steel brush for maximum results. More result you can visit custom metal fabrication
  2. Put the material to be welded in the place that has been provided. Whether it’s using a desk or just putting it on the floor. Adjust the density between the two materials. Use clamps if needed.
  3. If the material is very thick, make a coat on the part to be welded. May be one and may be both. So after later in united, there will be a place for later electrode fluid. So the welding process is really mature.
  4. Put the welding machine on one piece of material to be welded. Insert the electrode in the welding electrode welding panel. Mount the electrode slope to adjust to the position of the material. Usually there is a special place of electrode slope on electrode clamp pliers. Either it is perpendicular 90 degrees, 30 or 40 degrees. You must see one of the best shops for welding there was amazing machine for welding
  5. Once the material is ready for the weld, gently close the end of the electrode on the material to be welded.
  6. The distance between the tip of the electrode and the material to be welded greatly affects the quality of welding. If the distance is too far, there will be sparks like rain spots. The welding process will be imperfect. If the distance is too close, the fire does not flare perfectly. And there is not enough distance to place the melt of the electrode. A good distance is one-eighth of the thickness of the electrode. For more info about Welding you can visit welding calgary
  7. Using a protective mask or welding eyewear, you can pay attention to the melted electrode parts that integrate between the two welded materials. Gently move the electrode along the welded area.
  8. Gently rotate the electrode pliers if the welded area is wide enough until the electrode liquid closes the surface of the section to be welded.
  9. A good result when the welding process can be seen when the welded surface is shaped like a tight wave and regularly closes perfectly the welded part.
  10. When finished, clean the crust that covers the welded part using a hammer. Check back to see if there is an incomplete section. If not perfect, repeat the part that has not been well together. In some cases, the material that has been welded should be on the grind again if the welding is not perfect. But if it is not too fatal, we simply weld the part that has not been extensively in pursuit.